imported post
Well, as is headerd by my title, i have a a 4" .38 m15-3 that is my other primary carry pistol. The open bottomed blackwidow is just starting to get annoying after only 4 years of carrying in it. I dislike the barrel not being covered, since it helps protect the finish if i scrape up against something. I would like some good choices in 3 flavors.
1 Owb that can be worn from 3-500,
2 Iwb
3 iwb tuckable.
Im a big man and have love handles so that may be a factor.
Secondly, i have a Springfield armory milspec, and wear it in either a uncle mikes kydex holster, or a galco combat master. I dislike the kydex one becuase of its horrid adjustment range, and it sits low.
My dislike of the galco, is becuase it is very low and difficult to conceal, requiring me to get very very long shirts.
Secondly, i know i asked this before, but has anyone ever had a 1911 problem where the hammer digs into the love handles, and how did you fix it. I was thinking of getting a aftermarket hammer and beaver tail and having them installed and see if that helps out anybit. .
Any suggestions are welomed.
Well, as is headerd by my title, i have a a 4" .38 m15-3 that is my other primary carry pistol. The open bottomed blackwidow is just starting to get annoying after only 4 years of carrying in it. I dislike the barrel not being covered, since it helps protect the finish if i scrape up against something. I would like some good choices in 3 flavors.
1 Owb that can be worn from 3-500,
2 Iwb
3 iwb tuckable.
Im a big man and have love handles so that may be a factor.
Secondly, i have a Springfield armory milspec, and wear it in either a uncle mikes kydex holster, or a galco combat master. I dislike the kydex one becuase of its horrid adjustment range, and it sits low.
My dislike of the galco, is becuase it is very low and difficult to conceal, requiring me to get very very long shirts.
Secondly, i know i asked this before, but has anyone ever had a 1911 problem where the hammer digs into the love handles, and how did you fix it. I was thinking of getting a aftermarket hammer and beaver tail and having them installed and see if that helps out anybit. .
Any suggestions are welomed.